How to Go Green in your current Car, Truck, SUV or Recreational Vehicle

Microlon Family of ProductsAny engine that burns gasoline or diesel creates emissions and uses up valuable fossil fuels. But it is possible for a given engine to operate more efficiently, using less fuel and creating fewer emissions.

Much of the emissions created - and fuel used - are excessive wastes caused by the massive inefficiency of internal combustion engines.

According to scientists and engineers, the typical internal combustion engine is converting only 20 to 30 percent of the fuel it burns into useful power delivered to the vehicle's wheels. That means that up to 80 percent of the fuel you buy is wasted AND contributes to the noxious emissions coming out your exhaust pipe.

The greatest source of waste in your vehicle's engine is the friction that is created between dozens of metal parts rubbing against each other.

The metal-to-metal friction in an engine converts massive amounts of fuel energy into heat that must be dissipated by transfer to the air or a liquid coolant. The additional fuel used to overcome friction both needlessly adds to vehicle emissions, and also means that more fuel is needlessly purchased and used.

The best way to increase efficiency and reduce emissions created by internal combustion engines is to dramatically reduce the friction between moving parts. Less friction means less heat produced and less fuel used by the vehicle.

Microlon Engine Treatment, using nano-technology, deposits a permanent friction-reducing material on all metal-to-metal interfaces inside your vehicle's engine. This one-time treatment is the most cost-effective way to Go Green, improve fuel economy, and reduce the emission of toxic greenhouse gasses.

One lifetime treatment with Microlon will help protect both the global environment and your pocketbook. Reduced friction provides additional benefits as well, since engine wear is also substantially reduced.

Go Green - Go Microlon. Microlon nano-technology for your engine and the environment.

Microlon is FAA Accepted for use in piston aircraft engines of any size up to 1000-cubic inches displacement.

Microlon Brochure Link/PictureWhen you use Microlon's Three-Step process to dramatically reduce friction you'll immediately feel the extra horsepower and torque and you'll measure the increased gas mileage. MICROLON is a High-tech formula tested by independent labs, the Environmental Protection Agency (EPA) and the Federal Aviation Administration (FAA).

Microlon is a ONE-TIME metal treatment.

Once the Microlon resin is impregnated into the metal, NO further treatments are needed! Ever!!

Read our informational brochure.

More information about specific Microlon products is available.